Sony PCG-Z505JE - Manuel (Page 4)

Regulatory Information
If you have any questions about this
product, you can reach the Sony Customer
Information Service Center at
1-888-4SONYPC; or write to the Sony
Customer Information Service Center at
12451 Gateway Blvd., Ft. Meyers, FL 33913,
or find Sony Customer Service on the Web
at: http://www.sony.com/pcsupport.
The number below is for FCC-related
matters only.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
❏ Reorient or relocate the receiving
antenna.
❏ Increase the separation between the
equipment and the receiver.
❏ Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
❏ Consult the dealer or an experienced
radio/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
Only peripherals (computer input/output
devices, terminals, printers, etc.) that
comply with FCC Class B limits may be
attached to this computer product.
Operation with noncompliant peripherals
is likely to result in interference to radio
and television reception.
All cables used to connect peripherals must
be shielded and grounded. Operation with
cables, connected to peripherals, that are
not shielded and grounded, may result in
interference to radio and television
reception.
FCC Part 68
This equipment complies with Part 68 of
the FCC rules. On the bottom of this
equipment is a label that contains, among
other information, the FCC Ringer
Equivalence Number (REN) for this
equipment. If requested, this information
must be provided to the telephone
company.
This modem uses the USOC RJ-11
telephone jack.
The REN is used to determine the quantity
of devices which may be connected to the
telephone line. Excessive RENs on the
telephone line may result in the devices not
ringing in response to an incoming call. In
most, but not all areas, the sum of the RENs
should not exceed five (5.0). To be certain
of the number of devices that may be
Declaration of Conformity
Trade Name: SONY
Model No.: PCG-5211/PCG-5212/
PCG-5201/PCG-5202
Responsible Party: Sony Electronics Inc.
Address: 1 Sony Drive
Park Ridge, NJ 07656
Telephone: 201-930-6972
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.