Aube Technologies TA7210 - Manuel (Page 2)

Installation Guide
2
The equipment interface module (EIM) allows you to control a baseboard heater, a
convector or a fan-forced heater in a 120-volt, 208-volt or 240-volt application from a
EConnect™ wireless thermostat.
Installation procedure

Install the equipment interface module (EIM)............................................... Pages 3 - 6

Install batteries in wireless devices ..................................................................... Page 7

Link all devices to wireless network ........................................................... Pages 7 - 10

Exit wireless setup .............................................................................................Page 11

Customize thermostat (installer setup)......................................................Pages 11 - 18

Mount thermostat and outdoor sensor ..................................................... Pages 19 - 20
For error codes, see page 20.
To verify the signal strength, see page 21.
To replace a wireless device, see pages 21-22.
For specifications and replacement parts, see page 23.
SAVE THESE INSTRUCTIONS
System installation at a glance 1.
Remote
control
Thermostat
Outdoor
air sensor
Thermostat
EIM in remote
junction box
EIM in heater
Electrical
panel
Heater
Supply wires Wireless connection
69-2472EF-01 (Aube TA7210 System Installation Guide).book Page 2 Wednesday, June 29, 2011 1:15 PM