Alliance Laundry Systems 504523R3 - Manuel (Page 31)

504523 29
User-Maintenance Instructions . . .
Lubrication
All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Care of Your Dryer
Clean the lint filter before drying each load. The lint filter
may be washed if needed. Occasionally remove lint filter
and vacuum the area under it.
Ordinarily, the dryer cylinder will need no care.
Wipe the dryer cabinet as needed. If detergent, bleach or
other washing products have been spilled on the dryer,
wipe immediately. Some products will cause permanent
damage if spilled on the cabinet.
Do not allow sharp or rough objects to lean against the
dryer. The finish could be damaged.
Use only a damp or sudsy cloth for cleaning the control
panel. Some spray prewash products may harm the finish
on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
Exhaust System
The exhaust duct should be inspected after one year of
use and cleaned if necessary by a qualified service person
to remove any lint build-up. Inspect and clean exhaust
duct every one to two years as required thereafter.
The weather hood should be checked frequently to make
sure the dampers move freely, dampers are not pushed in
and that nothing has been set against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors and
liquids.
Do not obstruct the flow of combustion and ventilation
air.
NOTE: Verify proper operation after servicing.
For Energy Conservation . . .
• Make sure the lint filter is always clean.
• Do not overload dryer.
• Do not overdry clothes.
• Remove items to be ironed while still damp.
• Large loads of similar fabrics dry the most efficiently.
However, dry permanent press in smaller loads to
prevent wrinkling.
• Use the correct temperature FABRIC SELECTOR
setting for the type of fabric being dried.
• Locate your dryer so the exhaust duct is as short and
straight as possible.
• Do not open the door during the drying cycle.
• Plan to do your laundry on low humidity days; your
clothes will dry faster.
• Should you plan to dry several loads, do them one after
another, then you do not have to reheat the dryer’s
interior parts each time.
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause
improper and dangerous operation.
W049
CAUTION