AFX C130SNET - Manuel

C, CM, CMS, PC, PCMS Series Fluorescent Cloud Fixture
Models 2013, 2022, 2026, 2032, 2039, 2054, 2072, 213,113
Page 1 of 2 8060632 rev.2
Safety Precautions
Read all safety precautions and installation instructions
carefully before installing or servicing this fixture. Failure to
comply with these instructions could result in potentially fatal
electric shock and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture. (See labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A.
Disconnect electrical power before installing or servicing any part of this fixture.
B.
Remove fixture and hardware bag from cartoning.
2. Wiring.
All wiring must take place inside junction box. Caution : Make sure power is
off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
supply wires are within three inches of ballast use wire suitable for at least 90C (194F).
Note: Most dwellings built before 1985 have supply wire rated to 60C. Consult a
qualified electrician before installing.
A.
This unit will not operate properly unless connected to a “grounded” electrical
circuit. Electrical shock, over heating, low or no light output, and shortened
lamp life can result if proper grounding is not done. Securely attach green (or
green and yellow) wire to ground supply wire.
B.
Using wire connectors (provided), connect white supply wire to white ballast
lead. Connect black hot supply wire to black ballast lead. Do not mix wires.
Pull on each wire lead to make sure connections are secure. Make certain no
bare wires are exposed outside of wire connectors.
3. Mounting.
A.
Junction Box mounting; Attach Ceiling Pan (2) directly to Junction box
through eyelet holes (5) with two #8 –32 x 1 1/8” screws. (Provided)
4. Lamps
A.
Compact – Install lamps (6) by inserting lamp pins into lamp holder (3) and
press until lamp snaps in place.
B.
Circline- Install (small) lamp (8) around three inner clips (9) and connect
indicated socket from ballast to prongs on lamp. I nstall (large) lamp (7) around three outer clips (10) and connect indicated
socket from ballast to prongs on lamp.
5. Diffuser mounting.
A.
Align diffuser (1), inside Ceiling Pan and to lock the diffuser in place rotate the latch until it stops. Make sure all latches
lock.
6. Power to the fixture can now be restored.
7. Ballast is replaceable. Please contact customer service for ordering information.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period
of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due to improper
installation, misuse, mishandling or damage incurred in transit.