Samsung PN42A400C2DXZA - Manuel (Page 5)

English - 5
1 Unplug the cable or antenna from
the back of the TV.
2 Connect the cable or antenna to the
ANT IN terminal on the back of the
VCR.
3 Connect an Antenna Cable between
the ANT OUT terminal on the VCR
and the ANT IN terminal on the TV.
4
Connect a Video Cable between the
VIDEO OUT jack on the VCR and
the AV IN 1 [Y/VIDEO] jack on the
TV.
5 Connect Audio cables between the
AV IN 1 [R-AUDIO-L] jacks on the
TV and the AUDIO OUT jacks on
the VCR.
6 Press the SOURCE button on the
remote control until you see the VCR
signal (see “To Select the Source”
on page 10).
➢ If you have a “mono” (non-stereo) VCR, use a Y-connector (not supplied) to connect to the right and left audio input jacks of the
TV. Alternatively, connect the cable to the “R” jack.
If your VCR is stereo, you must connect two cables.
➢ Each VCR has a different back panel configuration.
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢ When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does not match the color of the video cable (Yellow).
Connecting a VCR
VCR Rear Panel
Video Cable (Not supplied)
Audio Cable (Not supplied)
 2
TV Rear Panel
Antenna Cable (Not supplied)
BN68-01822A-00Eng.indd 5 2008-08-12 오후 5:44:43