Samsung PN51D550C1FXZA - Manuel (Page 15)

English - 15
Network Connection - Wired
There are two main ways to connect your TV to your network using cable, depending on your network setup. They are
illustrated below:
✎
A network speed of lower of than 10 Mbps is not supported.
Configuring the Network Connection - Wired
Most home networks use the Dynamic Host Configuration Protocol (DHCP) to configure network connections. Home networks
that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS values your TV needs to access the
Internet so you don’t have to enter them manually.
To configure your network connection for a network that uses DHCP,
follow these steps:
1. Connect your TV to your network as shown in one of the
illustrations above.
2. Turn on your TV, press the MENU button on your remote, and then
select Network → Network Settings. The Network Settings
screen will appear.
3. Select Wired, press ENTER E, and then press ENTER E again.
4. The Network Connection screen appears, and verifies the network
connection. When the connection has been verified, the “Internet
connection successful.” message appears. Network set up is
completed.
✎
If your TV cannot acquire network the connection values automatically or if you want to set the connection
manually, select IP Settings on the network test screen. Set Internet Protocol Setup to Manual. You must enter
the IP Address, Subnet Mask, Gateway, and DNS Server manually.
✎
For more detailed information, see “Wired Network Connection” in the e-Manual.
The Modem Port on the Wall TV Rear Panel
LAN Cable (Not Supplied) Modem Cable (Not Supplied)
Extternal Modem
(ADSL / VDSL / Cable TV)
The Modem Port on the Wall
TV Rear Panel
LAN Cable (Not Supplied)
Network Settings
Select a network connection type.
Wired
Wireless(General)
WPS(PBC)
One Foot
Connection
Connect to the network using LAN cable. Please make sure
that the LAN cable is connected
U Move E Enter e Exit
[PD550-ZC]BN68-03448B-01L02.indb 15 2011-02-14 오후 4:19:03