Power Bright ML3500-24 - Manuel (Page 4)

that plug into AC receptacles to supply a low-voltage DC or AC
output to the appliance.
• Some fans with synchronous motors may slightly increase in
speed (RPM) when powered by the inverter. This is not harmful
to the fan or to the inverter.
• Route appliance cords and extension cords to prevent accidental
pinching, crushing, abrading and tripping people,
• Use safety approved extension cords rated at15 amps or higher.
• GFCI devices may not work with modified sine wave (MSW)
power.
• This inverter is not tested for use with medical equipment.
• This inverter is not tested for use in marine applications.
• In the event of a continuous audible alarm or automatic shut
down, turn the inverter OFF immediately. Do not restart the
inverter until the source of the problem has been identified and
corrected.
• When attempting to power lead acid battery chargers, with
modified sine wave, monitor the temperature of the battery
charger for approximately 10 minutes. If the battery charger
becomes abnormally warm, immediately disconnect it from the
inverter.
WARNING: DANGER OF BATTERY EXPLOSION –
INSTALL A FUSE
Battery Banks can deliver very high levels of current that can
vaporize metal, start fires and cause explosions. PowerBright
TM
recommends
installing one ANL type fuse and fuse holder close to the positive battery bank
terminal. This fuse protects the batteries from accidental DC cable shorts,
which can cause batteries to explode. ANL fuses and fuse holders are
available at most marine supply stores.
CAUTIONS
:
•
Loose connections can result in a severe decrease in voltage
•
that can cause damage to cables and insulation.
•
Failure to make correct polarity ( Pos, Neg ) connection between the
inverter and the battery bank can result in blowing fuses in the inverter
and can permanently damage the inverter. Damage caused by reversed
polarity is not covered under the PowerBright
TM
warranty.