STEINEL NM 5000-2-24 - Manuel (Page 6)

www.steinel.net (800) 852-4343 www.steinel.net (800) 852-4343
Setup and Commissioning
Light level setting (response
threshold)
The light level setting sets the level
at which lights will turn on and off.
The setting is concealed behind
the decorative faceplate.
• Place sensor in programming
mode:
- Press the programming
button. Lights will turn off
and the sensor function is
deactivated.
• Select the light level setting
- At the light level at which
you want the NM 5000-2-24
to switch connected load(s)
on, press the button until
the red LED (behind the
transparent housing) flashes.
- Release button, the new
ON level will be saved after
approximately 5 seconds.
• Important: While setting the
light level, do not cover it or
shade it with your own shadow.
• The last setting will remain
stored in the memory in the
event of a power failure.
• To reset to factory setting
(approx. 5 lux)
- Keep the button pressed for
approximately 5 seconds
until the red LED stops
flashing. The LED goes
on and Control is on for
approximately 3 minutes.
10
(factory setting:
darkness operation
approx. 5 lux
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux
Setup and Commissioning
Setting night economy mode
Night economy mode
automatically turns lights off at
specified times of the night when
lighting is not needed.
The night economy mode always
ends in the early hours of the
morning between approximately
4:00 and 5:00 a.m. The light then
switches on again when it gets
dark if the setting for morning
hours is in the ON position.
Factory setting is for the light
to switch OFF at approximately
1:30 a.m. (There is no clock in
the electronics.
All time values are computed
by the microprocessor on the
basis of ambient light levels at twilight. Seasonal changes in light
levels are automatically taken into
account.)
Setting for morning hours
When the morning setting is
counterclockwise (OFF), lights
will stay off in the morning. Fully
clockwise (ON) will have lights
turn on in the morning between
approximately 4:00 and 5:00
a.m. and remain on until the set
brightness level is achieved.
11
(factory setting:
Light ON in the
morning)
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux
OFF ON
LED
24
6
21 3 =
24
6
21 3 =
OFF
24
6
21 3 =
OFF
Morning
Vario OFF
Night
No night,
economy
mode Medium night,
economy
mode Long night,
economy
mode
(factory setting: OFF at
approx.130 a.m.)
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux
ON OF F
Mo rnin g Var io O FF Nig ht
OFF ON Morning Vario OFF Night Vario OFF OFF ON Morning t OFF ON Morning Vario OFF Night
Vario OFF
Night
OFF ON
Morning 0,5 – 100 Lux