HP Cadre photo numérique HP df840v1 - Manuel (Page 15)

15
4. Double-click the desired drive to display the files on the card.
5. To copy files from a media source, select and drag them into the DPF’s internal memory drive (HP_DPF).
6. Similarly, to copy files from your computer to the internal memory, first locate the files on your computer,
select the files you want to copy, and then drag and drop them into the DPF’s internal memory drive.
TIP: Most cameras and graphic programs store photos in the Windows XP ‘My Pictures’ or Vista ‘Pictures’
folder. If you didn’t save them to any other location, you may find them there.
Disconnect DPF from Windows PC
It is important to always perform a safe PC ‘release’ before disconnecting the DPF USB cable from the PC.
WARNING: Do not unplug or switch off the DPF when files are being transferred, as that can seriously
damage the memory.
Windows Vista
1. On the Windows System Tray, click the hardware removal icon.
2. Click the Safely remove USB mass Storage device message corresponding with the DPF device drive.
3. When the message “This device can now be safely removed from the computer” appears, you can
disconnect the USB cable from your computer.
Windows XP
1. On the Windows System Tray, click the hardware removal icon.
2. Click Remove Hardware Safely.
3. Select the storage device corresponding with the DPF, and then click Stop to disconnect. A final dialog box
opens.
4. Click Close.
5. When the message “It is now Safe to Disconnect Hardware” appears, you can disconnect the USB cable
from your computer.
Connect DPF to Macintosh Computer
1. Use a USB cable to connect the DPF to your Macintosh computer.
2. Macintosh will recognize the DPF as an external storage device.
3. Drag and drop files between the two devices as you normally move files.
Disconnect DPF from Macintosh Computer
1. To safely disconnect the DPF from your Macintosh, select DPF’s icon on your desktop and press
Command-e to eject the disk.
2. When the icon is no longer on the desktop, it is safe to unplug the USB cable.
The DPF will stay on until you power it off, however, to save power you can set it to automatically go into a
sleep mode when left idle for a specific amount of time.
1. On the HOME screen, press to display the Setup Menu.
2. Select Set Sleep Mode, and then select the desired setting.
OFF (default) = Power saver is ‘disabled’; DPF will remain on until you power it off or change the sleep mode
setting 2/4/8 Hours = The DPF will automatically go into sleep mode when left idle the specified amount of time
3. Select Done.
Set Sleep Mode
!