Electrolux EGT6142NOX - Manuel (Page 11)

A B C
A) End of shaft with nut
B) Washer
C) Elbow
Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).
"Flexible" connection with
mechanical end:
– Natural gas: connection carry out with
a flexible pipe with mechanical end
which is screwed directly on the elbow
finishing the slope of the appliance.
– Butane / Propane: use a flexible tube,
equipped with it's collars if it is worth
visiting over all it's length and if the ap-
pliance runs only on butane. If the ap-
pliance runs on Propane, use a flexible
pipe with suitable metal end.
Flexible nonmetal pipes
connection:
If it is possible to easily control the con-
nection in its full area, you can use a flexi-
ble pipe. Tightly attach the flexible pipe by
clamps.
Liquid gas: use the rubber pipe holder.
Always engage the gasket. Then continue
with the gas connection. The flexible pipe
is prepared for apply when:
– it can not get hot more than room tem-
perature, higher than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting
edges or corners;
– it can be easily examined in order to
check its condition.
The control of preservation of the flexible
pipe consists in checking that:
– it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length;
– the material is not hardened, but shows
its correct elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not
repair the pipe, but replace it.
When installation is complete,
make sure that the seal of each
pipe fitting is correct. Use a soapy
solution, not a flame!
8.2 Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type
of gas you use (see table in "Techni-
cal Information" chapter).
4. Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find
this plate in the package supplied
with the appliance.
If the supply gas pressure is changeable
or different from the necessary pressure,
you must fit an applicable pressure ad-
juster on the gas supply pipe.
8.3 Adjustment of minimum level
To adjust the minimum level of the burn-
ers:
1. Light the burner.
2. Turn the knob on the minimum posi-
tion.
3. Remove the knob.
4. With a thin screwdriver, adjust the by-
pass screw position.
ENGLISH 11