7 specifications – AKG Acoustics PERCEPTION 820 Manuel d'utilisation
Page 18
18
PERCEPTION 820 TUBE
7 Specifications
7.1 Microphone
7.2 Remote Control Unit
Type:
1-inch dual-diaphragm, true condenser pressure-
gradient microphone
Polar patterns:
omnidirectional, cardioid, figure eight plus six
intermediate patterns (selectable on Remote
Control Unit)
Open-circuit sensitivity
at 1kHz (cardioid):
20 mV/Pa (-34 dBV ±3 dB)
Frequency range:
20 Hz to 20 kHz (see frequency response graphs)
Impedance:
≤ 200 ohms
Recommended load impedance:
≥ 1000 ohms
Equivalent noise level
to IEC 60268-4 (A-weighted):
16 dB-A
Signal/noise ratio re 1 Pa (A-weighted): 78 dB
Max. SPL:
135 / 155 dB SPL (0 / -20 dB)
Preattenuation pad:
-20 dB (switchable on Remote Control Unit)
Bass cut filter slope:
12 dB/octave, 80 Hz
(switchable on Remote Control Unit)
Environment:
temperature: -10°C to +60°C
R.H.: 80% (+25°C)
Powering:
via Remote Control Unit only
Connector:
dedicated 7-pin male XLR
Dimensions:
53 dia. x 212 mm high / 2 x 8.3 in.
Net weight:
870 g / 1.9 lbs.
Audio/control input:
dedicated 7-pin female XLR connector
Audio output:
standard 3-pin male XLR connector,
balanced, pin 2 hot
Polar pattern selector:
9-position detented rotary switch
Bass cut filter switch:
2-position toggle switch
Preattenuation switch:
2-position toggle switch
Power voltage:
210-240 VAC or 110-120 VAC, selectable
Primary fuse:
125 mA / 250 V slow-blow
Perception_820_Manual_final4_C030818 02/05/2009 11:26 Seite 18 (Schwarz/Black Auszug)