Bosch SGE63E06UC - Manuel (Page 13)

11
Attaching the Toe Panel
Your dishwasher comes with either a two-piece or
three-piece toe panel (model dependent) to allow
height adjustment.
1. Position the slotted rear toe panel on the
dishwasher first. Allow it to rest on the floor.
2. Position the mating front toe panel on top of the
rear toe panel allowing the angled edge to rest
on the mating edge of the dishwasher.
3. Drive the two black screws (B) through the holes
in the toe panel to secure. Use the supplied
screws to avoid damaging the dishwasher. See
Figure 26.
4. For models with a three-piece toe panel, the
rubber apron removed earlier may now be
attached and should remain behind the
outermost toe panel.
5. For models with outer toe panel (3rd piece - L)
slide the brackets (K) provided, into the slots of
the toe panel you just attached.
6. Once you determine the correct position for the
brackets, remove the bracket and bend the metal
tab. See Figure 27. This ensures that the toe
panel will not slide in further than you need.
7. Re-insert the brackets.
8. Attach the outer toe panel (L) onto the brackets
and drive the screws provided in place to secure
the toe panel ensuring that the rubber apron is
completely hidden behind the outer toe panel.
Figure 26
Figure 27