Edwards Signaling Genesis WG4 Outdoor Horn-Strobe - Manuel

© 2012 UTC Fire & Security. All rights reserved. 1 / 10 P/N 3102000-ML • REV 1.0 • ISS 11APR12
Genesis WG4 Outdoor Horn-Strobe
Installation Sheet
EN FR
EN: Installation Sheet
Description
The Genesis WG4 Outdoor Horn-Strobe is a life safety
notification appliance designed for indoor or outdoor use on
ceilings or on walls. See Table 1 for a list of models and
Table 2 for a list of accessories.
For surface mount applications, mount the WG4 onto a Model
449 electrical box using the gasket shipped with the appliance.
For flush mount applications where the mounting surface is
flush with the surface of the wall or ceiling, use the WG4GSKT
gasket kit.
Note that you need a Model 449 electrical box for waterproof
applications, or a standard mount 4in. square box for all other
applications.
The horn-strobe includes field-configurable jumper options that
allow you to set the strobe pattern to temporal or continuous,
the horn pattern to temporal or continuous, and the horn
volume to low or high. The horn-strobe also includes a field-
configurable switch for setting the strobe candela level. This
setting is locked in place and is visible after final installation.
Table 1: Models
Number Description
WG4WF-HVMC Outdoor rated wall/ceiling horn-strobe, white with
FIRE marking, clear lens
Number Description
WG4WN-HVMC Outdoor rated wall/ceiling horn-strobe, white
without marking, clear lens
WG4RF-HVMC Outdoor rated wall/ceiling horn-strobe, red with
FIRE marking, clear lens
WG4RN-HVMC Outdoor rated wall/ceiling horn-strobe, red without
marking, clear lens
Table 2: Accessories
Number Description
WG4WTS [1] Outdoor-rated surface skirt, white, for Genesis WG4
horn or horn-strobe
WG4RTS [1] Outdoor-rated surface skirt, red, for Genesis WG4
horn or horn-strobe
WG4GSKT [2] Appliance replacement gasket, flush mount
[1] The trim skirt is outdoor-rated when used with the Model 449
electrical box.
[2] Not compatible with the trim skirts.
To synchronize horn-strobe operation, you must install a
separate synchronization source. See Table 3. When
connecting the horn-strobe to a listed control panel, verify
synchronization operation on the compatibility list for the
corresponding panel.
Table 3: Compatible synchronization source models
Description Number
Auto-sync output
module SIGA-CC1S SIGA-MCC1S
GSA-CC1S GSA-MCC1S
SIGA-CC2A SIGA-MCC2A
Genesis signal master -
remote mount ADTG1M-RM MG1M-RM
EG1M-RM XLSG1M-RM
G1M-RM
ZG1M-RM
Booster or auxiliary
power supply APS10* EBPS10*
APS6* EBPS6*
BPS10* MIRBPS10*
BPS6* MIRBPS6*
EAPS10* XLS-BPS10*
EAPS6* XLS-BPS
* Represents any number of additional characters
Installation
Install this device in accordance with applicable requirements
and in accordance with the local authorities having jurisdiction.