ShelterLogic 25730 Canopy Extension/Sidewall Kit - Manuel (Page 5)

05-25730-0E Page 5
4. ANCHOrING AND rOPE TOGGLES
5. TIGHTEN THE COvEr WITH CLAMP TWIST TITE ™
A. Mount the clamp and new TwistTite ™ cable so it
holds onto the rope that is still threaded through
the canopy cover edges.
B. The clamp should be mounted approximately
6" to 10" up from the corners.
C. Wrap the cord with plastic ball and "S" hook at
the corners of the cover around the corner leg
poles. Insert "S" hook into the hole of the corner
leg poles.
D. Twist each leg pole toward the outside of the
shelter until the cover becomes tight.
Twist the leg poles equally to ensure the cover stays
aligned during tightening.
A. Thread the Guy Ropes 10437 through the Rope Toggle 10436 as shown below. Tie a knot at the end of
the rope to keep it from sliding out of the rope toggle.
B. Make a loop knot at the other end of the rope and place it over the tab the the top of the tent pole.
C. Place the anchor securely in the ground about 3’ from each tent pole.
D. Tighten anchor rope with rope toggle.
This is a temporary spike anchor. Not intended for permanent use.
Spike Anchor
10436
Thread Guy Rope Through Rope Toggle
10447
Knot
Top view Anchor Ropes Setup
Ropes &
Anchors
Canopy
12082
3'
Clamp Twist-Tite ™ Attach Clamp
10462
6" - 10"
Rope threaded
through edge
of canopy cover
Top of Tent Pole