CAMPO EQUIPMENT BLAZE 9E - Manuel (Page 5)

BLAZE 9E MANUAL
MAINTENANCE
WARNING!
NEVER SERVICE THE HEATER WHILE IT IS PLUGGED IN, RUNNING OR HOT. SEVERE BODILY INJURY
OR ELECTRIC SHOCK MAY OCCUR.
ONLY QUALIFIED PERSONS ARE ALLOWED TO OPEN HEATER FOR SERVICE. NO USER-SERVICE-
ABLE PARTS INSIDE.
• Keep heater clean. Use pressurized air to blow fan blades clean. Note! Use moderate pressure to avoid
damage to fan blades
• Inspect heater before and after each use
• The fan motor is sealed and has permanently lubricated bearings
STORAGE
When not in use, the heater must be disconnected from power source, cleaned of dust and stored in a dry
place.
The power supply cord should be loosely wound around the handle of the heater.
TECHNICAL SPECIFICATIONS
HEAT OUTPUT BTU/Hr 30,700 (9,000W)
AIRFLOW CFM 550
ELECTRIC CONNECTION V ac / Hz 240 / 60 single phase
AMPERAGE DRAW A 36.5
POWER CORD 3x8 AWG
PLUG NEMA 14-50P
EXTENSION CORD min. 3x8 AWG
AMBIENT THERMOSTAT temp. range 32 - 150 °F (0 - 65 °C)
LENGTH inches 23.5
WIDTH inches 13.5
HEIGHT inches 17
WEIGHT lbs 45
Campo Equipment Co. Ltd. 1 866 323 0042 wwww.campoequipment.com