Amana W10245579A - Manuel (Page 8)

8
3. Use a rubber hose connector (not provided) with screw-type
clamps (not provided) to connect the air gap to the waste tee
above the drain trap and at least 20" (50.8 cm) above the floor.
4. Insert the drain hose through the hole cut in the cabinet and to
the front and center of the opening where the drain
connection will be made.
Connect Drain Hose to Waste Disposer—No Air Gap
1. Remove the waste disposer knockout plug.
NOTE: Do not cut the end of the drain hose.
2. Attach the drain hose to the waste disposer inlet with the large
drain hose clamp (provided).
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor.
NOTE: It is recommended that the drain hose be looped up
and securely fastened to the underside of the counter.
3. Insert the drain hose through the hole cut in the cabinet and to
the front and center of the opening where the drain
connection will be made.
Connect Drain Hose—No Waste Disposer or Air Gap
1. Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
2. Attach the drain hose to the waste tee with the large drain
hose clamp (provided).
NOTES:
■ If the drain hose was cut, use 1 ¹⁄₂" to 2" (3.8 to 5 cm)
screw-type clamp (not provided).
■ This connection must be before the drain trap and at least
20" (50.8 cm) above the floor.
■ It is recommended that the drain hose be looped up and
securely fastened to the underside of the counter.
A. Drain hose—cut here, if needed
B. Screw-type clamps (not provided)
C. Air gap
D. Large drain hose clamp
(provided)
E. Drain hose
F. Rubber hose connector
(not provided)
G. Waste tee
H. Drain trap
A. Drain hose
E
D
C
G
H
A
B
F
A
A. Large drain hose clamp (provided)
B. Drain hose C. Disposer inlet
D. Drain trap
A. Drain hose
A. Drain hose—cut here, if needed
B. Large drain hose clamp (provided)
C. Drain hose
D. Drain trap
E. Waste tee
B
A
C
D
A
E
D
C
A
B