Controlled Products Systems Group 361LM - Manuel (Page 2)

SET THE DIP SWITCHES
1
Press and release the Smart/Learn button
on your product. The LED will light.
2 Within 30 seconds press and hold the
button on the remote control that you
wish to activate your product.
Programming is complete.
Repeat the steps above for each button and/or
remote control you would like to program.
Programming the remote control to
an existing remote control
Locate the dip switches in the new and old
remote controls. Place remote controls side by
side and set the dip switches in the remote
controls to matching positions (+,0,-).
Programming a 3-button remote
control
When programming a single or 2-button
remote control to a 3-button remote control it
is very important to set dip switch #1 to the
correct position. The dip switch in the single or
2-button remote control MUST correspond to
the buttons on the 3-button remote control as
shown.
Example: If you are programming a
single-button remote control to the middle
button on the 3-button remote control, dip
switch #1 in the single-button remote control
MUST be set to “0” in order for both buttons to
work.
PROGRAMMING
Programming the remote control
without an existing remote control
Set the dip switches in the remote controls to
any position you want (+,0,-).
+
0
–
1 2 3 4 5 6 7 8 9
+ 0 –
12
3
4
5
6
7
8
9
+ 0 –
12
3
4
5
6
7
8
9
=
+ 0 –
12
3
4
5
6
7
8
9
+ 0 –
12
3
4
5
6
7
8
9
=
+ 0 –
1
+
0 -
New Remote Control
New Remote Control
3-Button
Remote Control Single or 2-Button
Remote Control
2
Dip switch #1 must
correspond to the
3-button remote
control buttons
Existing Remote Control
1
2
Use a pen or screwdriver to slide the dip switches.
Smart/Learn Button