Kolpin 20036 – UTV Double Gun Boot Mount - Manuel

20036 UTV Double Gun Boot Mount
20036 Assembly:
1. Attach the Mounting Plates (2X) to the Slotted U-Channel using the 6 – 5/16” bolts, and 12 flat
washers and 6 – 5/16” Nylock Nuts. Tighten securely.
2. Attach the Gun Butt Holder with 6 slots (2X) to the Mounting Plate using the 8 – 5/16” Carriage
Bolts, 8 – 5/16” Washers (one underneath) and 8 – 5/16” Nylock Nuts.
3. Attach the Gun Barrel Holder (4 slots) to the Mounting Plate using the 4 – 5/16” Carriage Bolts, 4
– 5/16” Flat Washer and 4 – 5/16” Nylock Nuts.
4. Place Gun Boot in holder and pin in using the Locking Pin provided.
NOTE: In some instances it may be easier to mount the U-Channel to the UTV before
assembling.
20036 Mounting:
1. Attach the 20036 UTV Double Gun Boot Mount to the roll bar of your UTV Using the 2 – 3/8” U-
Bolts, 4 – 3/8” Washers and Nylock Nuts provided.
2. For roll bars with mesh use the 3/8” Hex head bolts, washers and nuts.
20036 Uses:
• Allows you to carry your guns safely and securely while riding your UTV, keeping the elements
off of your gun.
CAUTION: Always make sure gun is unloaded before placing it in your Gun Boot IV.
NOTE: Gun Boot 6.0 is not compatible with this mount.
Kolpin Powersports, Inc.
107 Industrial Drive, Fox Lake, WI
Phone #: (877) 9KOLPIN or (920) 928-6514
www.kolpinpowersports.com
[email protected]
Description Quantity
Slotted U-Channel 1
Mounting Plates 2
Gun Butt Holder 2
Gun Barrel Holder 2
5/16” Hex Head Bolt 6
5/16” Flat Washer 24
5/16” Nylock Nut 18
5/16” Carriage Bolt 12
3/8” U-Bolt 2
3/8” Washers 12
3/8”Hex Head Mounting Bolt 8
3/8” Nylock Nut 8
Locking Pin 2