Kolpin 97700 - Backup Vision - Manuel

L I G H T A S S E M B L Y
I N S T R U C T I O N S
Halogen Lamp
And
Mounting
Hardware
Light cable assembly has
three components:
A). Switch Select for continuous
lighting or light active only
when in reverse.
B). Halogen Lamp
(PETERSON)
C). Red battery terminal wire
with 10 amp series fuse.
REVERSE SWITCH CONNECTION:
Connect the yellow wire to the Reverse indicator light wire.
LAMP CONNECTION:
Connect Halogen Lamp black wire to red wire.
Connect the opposite end of the red wire to the positive battery terminal.
Red Wire with
10 Amp Fuse
CAUTION
Failure to follow the instructions and warnings contained in this document and on the Back-up Vision can result in
severe injury or death.
Read and understand your ATV owner’s manual for risks associated with ATV use and suitability of the Back-up Vision
for use on your ATV.
CAUTION
LIGHTS ARE HOT! Hot lights can cause serious burns. Do not touch or service lights until cool.
CONSULT STATE AND LOCAL LAWS AND REGULATIONS. Consult state and local laws and regulations for ATV lighting
and visibility requirements.
CAUTION
Failure to follow wiring instructions may cause fire, property damage, severe injury or death.
Use the enclosed hardware to affix the Back-Up light to the rear of the ATV.
Route the wires along the frame and use plastic wire ties or electrical tape to
secure the wires. Be sure the wires are not in an area they may become damaged.
Make sure that all fasteners are tight and the wires have been safely secured.
Turn on light and adjust direction of light beam.
SERVICE AND MAINTENANCE
These lights require occasional cleaning and service. The frequency and extent of
cleaning will vary depending on the conditions where the product is used.
• Remove rubber boot and unscrew bulb base.
• Wipe the bulb after changing with isopropyl/rubbing alcohol.
Do not touch the lamp after cleaning. Skin oils cause the bulb to burn out.
For additional assistance, please contact our customer service department at 1-877-9KOLPIN or [email protected]
U-Bolt, 6mm x 25mm
Truss Screw, 5mm x 10mm
Light Bracket
6mm Nylock Nuts
ATV Light
WARNING
WARNING
WARNING