Draw-Tite 59770 ROOF RACK - Manuel (Page 2)

8. With one strap loosely mated around the door frame,
hold the other side Strap out from the body side and place
into the door frame. (Fig. 2c)
Ensure the rubber pads on the straps are in place to avoid
paint damage.
9. Using the supplied “L” wrench tighten the bolts to pull
the Straps up towards the door frame. (Fig. 2d)
Tip: While tensioning the Straps alternate from side to
side to ensure even tension on both sides.
Attaching Covers to End Supports
Should you need to remove your GTX covers the
following describes the replacement and use.
10. Locate the ends of the Hinge with the Cover
hinge holes. Flex the Hinge ends in and push
through the Cover holes until the capped ends
engage. (you’ll hear and audible click) (Fig. 3a & 3b)
11. To fully extend the Covers away from the Support
(to access the Accessory Channel or mounting
hardware) Pivot the Cover on the Hinge while
pushing down on the top of the Cover. (Fig. 3c)
Locking Covers and Mounting Accessories
12. You are now ready to mount your accessories examples: Bike,
Kayak, luggage carriers by using the Accessory Channel if
applicable. “T” bolts are available to mount accessories. (Fig. 4a)
Be sure to cut your buffer strips to size to completely cover
your channel once the accessories are mounted.
13. Lock all four covers into place using the keys
provided. (Fig. 4b) Store your keys in a safe place such
as the glove box or key ring. Replacement locks and
keys are available as a service items.
14. Ensure all covers are pushed up hard against the
End Supports. (Fig. 4c & 4d) You’ll hear an audible
“click” when the cover is fully engaged.
General Usage Information
* It is essential for the proper assembly, operation and use of the Roof Rack that the
instructions and safety precautions supplied are strictly observed.
* The maximum permissible load for your roof rack is the lower of the maximum load capacity
specified in you owners manual or specified on your roof rack load label. Do NOT exceed the
maximum load capacity.
Maximum load capacity equals the weight of the rack + accessories + weight of cargo.
Ensure your vehicle’s function is not impaired before driving.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution. Check the function of all doors and sunroof before driving.
For lost key replacement or other service items call customer service: 1-800-632-3290 or visit: www.rolaproducts.com.
Please have lock core number or part numbers available.
Loads should be evenly distributed and secured. REGULARLY CHECK THE TIGHTNESS OF LOCKING STRAPS.
Page 2 of 2 Printed in China
Ensure bars are parallel and straps are tightened fully.
Perform a check by tugging on the cross bars.
Accessory
Channel
Access
LOCK
locked
Un-locked
CLICK
Installation Instructions: Ford Edge / Lincoln MKX – without roof rails 2007 - On
Fig. 3a
Fig. 3c
Fig. 3b
Fig. 4a
Fig. 4d
Fig. 4c
Fig. 4b
CLICK
Make sure the support hooks
mate with the slots on the
Gasket Pads.
PUSH
PULL
Front of Vehicle
Fig. 2c Fig. 2d
Front of
Vehicle
If required, use a plastic
tool to pull seal back then
install strap under seal.
59770N Rel. 7-9-12