Draw-Tite 59839 ROOF RACK - Manuel

Prior to Assembly, check that your Roof Rack Box contains all the parts
as shown above. Ensure that the vehicle roof is clean and dry.
Please note that some illustrations depicted in these instructions are
only representative and your items may look different.
Read these instructions carefully before commencing.
You can use a protective cloth when installing your racks to protect
of vehicle’s finish.
Ensure your straps correspond with the mounting positions on
the vehicle before installing them into the End Supports. Use
strap notches as shown above to identify the correct car position
1. Un-fasten and rotate the Covers off the End Supports. The
Covers can remain attached to the Hinge on the Supports.
2. Remove the Gasket Pads by carefully pulling them off the
End Supports (Pads are clipped on by “T” clips).
3. Feed the Strap neck through the cavity in the End Support (Fig 1a).
When the Neck is through rotate the Strap down and then push up to
align the bolt hole and the cage nut.
4.Use the supplied “L” wrench to feed the bolts into the cage
nuts (Fig 1b). The “L” wrench is located inside the support.
5. Leave approximately 1” (25mm) of gap between the top of
the Strap and the bolt head . This will aid in installation to the
door frame (Fig 1c)
TIP: Pull the Buffer Strips back
approximately 1-1/2” (40mm)
to allow good access for the “L”
wrench to fit into the bolt
head.
6. The Gasket Pads all have vehicle roof
position text on the top inside surface.
Left (Drivers side), Right (Passenger side)
These can now be replaced on the end
supports. Re-fasten using the T clips
7. Using the vehicles B pillar place the
cross bars as specified in ( Fig 2 a & b)
Note: Gasket only shown for clarity.
Note- You may place the cross bar
position labels in the door frame
below the Straps for future reference.
Kia Forte Sedan
2010 and Up
Roof Rack Installation Guide
PART No.
700mm (27-1/2” )
Fitting Straps into End Supports
Placement of End Supports onto Vehicle Roof
Page 1 of 2
KIT COMPONE
N
TS
Fig 1a
Fig 2b
Fig 2a
Fig 1c
Fig 1b
25mm
(1”)
265mm
(10-1/2”)
Front
Front
Door op
ening
1
2
Gasket Pads are pre-
attached to the Supports
Forwa
rd
Note: Keys may be
packaged separately
in the kit
B
-P
ill
ar
Carrying Capacity
110 Lbs./
50 Kgs.
59839
59839N Rel. 1/21/11