Avocent AutoView AV2000BC - Manuel (Page 40)

30 AutoView 2000 Installer/User Guide
Figure 3.16: Diagnostics Dialog Box
Next to each item to be tested, you will see a pass (green circle) or fail (red x) symbol display to
the left of each item as that test finishes. The following table details each of the tests.
To run diagnostic tests:
1. If the OSCAR interface is not open, press Print Screen . The Main dialog box will appear.
2. Click Commands - Run Diagnostics. A warning message displays indicating that all users will
be disconnected.
Table 3.5: Diagnostic Test Details
Test Description
Memory Tests Reports on the condition of the main board RAM
Firmware CRCs Reports on the condition of the main board RAM
Comm Interfaces Validates the current firmware images stored in the system’s FLASH
Switch Controller test Verifies the switch matrix controller is accessible and functional
Local Video Indicates the condition of the local video monitor
On-line AVRIQ modules Indicates the total number of currently connected and powered AVRIQ modules
Offline AVRIQ modules
Indicates the number of AVRIQ modules that have been connected successfully
in the past and are powered down
Suspect AVRIQ modules
Indicates the number of AVRIQ modules that have been detected, but are either
unavailable for connection or have dropped packets during the ping tests