atwood Camper Jack Retrofit Kit - Manuel

ENGLISH •Installation •Operation •Maintenance
Effective 12/10/07
LITERATURE NUMBER
MPD 87438
CAMPER JACK RETROFIT KIT
9
The Retrofit Kit is designed for use with Atwood ®
Electric Ball Screw Camper Jacks that have replaced
manual camper jacks.
REFER TO MPD 87903
FOR COMPLETE JACK INSTRTUCTIONS.
Position the camper on the truck and fully retract the
manual jacks. Remove the manual camper jacks.
INSTALLATION
1. Determine the placement of the electrical connectors
provided in the kit on the front and rear of the camper
as shown in
FIG 1. For remote controlled electric
camper jacks, install 2-wire connectors at all four
corners. For non-remote controlled electric camper
jacks, install the 4-wire connectors on the driver side of
the camper and the 2-wire connectors on the
passenger side. Mount the connectors within 5” from
the edge of the camper (see
FIG 1-A).
2. Install the jacks per instructions in MPD 87903. For
remote controlled jacks, install one jack at each corner.
For non-remote controlled electric jacks, place the
jacks with switches on the driver side of the camper
and the jacks without switches on the passenger side.
3. Make electrical connections in 30 amp circuits with
fuses located within 18” of the battery. Use 10 gauge
stranded copper wire. Wiring must meet applicable
RVIA codes per ANSI A 119.2, NFPA 1192.
a. For remote controlled jacks, make the connections
in individual circuits. Refer to FIG 4.
b. For non-remote controlled electric camper jacks,
make the connections in two separate circuits,
one for the front jacks and one for the rear jacks.
Refer to
FIG 2.
4. To use the manual override handle, push the handle ( FIG
3-A) into the jack alignment tube ( FIG 3-B) and engage
the drive pin. Rotate the handle counterclockwise to
raise the camper (extend the jack) or clockwise to
lower the camper (retract the jack).
3
A
B
2
F
G
C
E
D
A
B
A
1
A - Driver Side
B - Passenger Side
C - Red w/ white stripes
D - 30 AMP fuse
E - Black w/ white stripe
F - Black
G - Red
4
A - Driver Front Jack
B - Passenger Front Jack
C - Driver Rear Jack
D - Passenger Rear Jack
E - 40 AMP Circuit Breaker
F - Black (-)
G - Red (+)
H - Input Power Terminal Block
I - Jack Terminal Block
J - Flat Cable
K - Antennae
WIRING FOR REMOTE CONTROLLED JACKS
WIRING FOR NON-REMOTE JACKS
PR-
12V GND
DR- DR+ PF- PF+ DF- DF+ PR+
MPD85439
ATWOOD MOBILE
PRODUCTS
®
H
E
J
D
F G F G
C
F G
A
B
F G
I