Gotham ROUGH-IN SECTION for DP, DMRH and DLV - Manuel (Page 4)

FEED WIRE CONNECTION TO FIXTURE J-BOX Refer to Figure 5.
J-box is approved for through wiring witheight No. 12AWGconductors
(4in/4out) rated 90°C or higher.
1. Remove j-box cover by releasing spring clip (A) and allowing cover
(B) to hinge open.
2. Select knockout, remove, and install appropriate connector.
3. Install feed wire in accordance with and/or local electrical codes.
4. Complete wiring.
5. Reinstall j-box cover (B).
SOCKET ASSEMBLY REPLACEMENT (LOW VOLTAGE UNITS ONLY)
1. Remove trim by gently pulling down until butterfly springs are visible.
Squeeze springs together to release fromthe slots provided in the hous-
ing. Refer to Figure 6.
2. Unplug lamp from socket and set trim aside.
3. Follow the socket wire inside housing until it terminates at the plug
connection. Squeeze the two tabs on the outside of the plug and re-
move.
4. Install replacement socket assembly in reverse order of the above.
Note the plug is polarized.
LAMP REPLACEMENT (MR16, AR70, PAR36, AR111, PAR46, PAR56)
Refer to Figure 7.
1. Refer to #1 and Figure 6 from SOCKET ASSEMBLY REPLACEMENT.
2. Remove lampholder bracket (A) by releasing lampholder retaining
spring (B).
3. Remove lens if applicable.
4. Remove socket from lamp.
5. Remove lamp from lampholder bracket. Replace with new lamp.
6. Reinstall lampholder bracket by aligning tab (C) with slot in adjustment
mechanism (D).
7. Rotate upwards and snap into position.
8. Replace lamp/lampholder and trim.
TRANSFORMER/BALLAST REPLACEMENT Refer to Figure 8.
1. Refer to #1 and Figure 6 from SOCKET ASSEMBLY REPLACEMENT.
2. Remove lamp/lampholder and trim from fixture.
3. Rotate adjustment mechanism (A) to allow access to j-box access
door (B).
4. Loosen the knurled thumb screw (C) that can be seen through the
aperture.
5. Slide j-box access door to the side. Remove outside j-box door with
transformer (D) attached. Unwire transformer.
6. Install replacement in reverse order.
7. Replace lamp/lampholder and trim.
INSULATION DETECTOR REPLACEMENT Refer to Figure 9.
1. Refer to #1 and Figure 6 from SOCKET ASSEMBLY REPLACEMENT.
2. Rotate adjustment mechanism (A) to allow access to j-box access
door(B).
3. Loosen the knurled thumb screw (C) that can be seen through the
aperture.
4. Slide j-box access door to the side.
5. Removeinside j-box door withthermal protector (D)attached.Unwire.
6. Install replacement insulation detector into holder and reinstall in
reverse order.
7. Replace lamp/lampholder and trim.
Figure 5
Figure 6
Figure 8
Part No. CJ520658 REV. C
2/2014
Figure 7
A
B
C
D
Figure 9
A
B
C
D
A
C
B
D
A
B