Gotham EVO LW Trim - Manuel (Page 2)

CJ5201028 Rev. C
11/2013 2 of 6
©2010 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
EVO LW
Trim
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
Electric current can cause painful
shock or serious injury unless handled
properly. For your safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
Installation EVO LW Trim
1. Pull junction box with quick connect (included with mounting frame) through ceiling opening as shown in Figure 1.
2. Insert quick connect into PC board connector as shown in Figure 2.
3. Fasten junction box to the trim by engaging screw in slot and tightening securely as shown in Figure 3.
4. Mounting frame is provided with trim retention “C” brackets as shown in Figure 4. Compress trim assembly
retention springs and engage with “C” brackets as shown in Figure 5.
5. Push reflector into ceiling opening as shown in Figure 6 making sure that wallwash component is properly
oriented with respect to the wall to be illuminated as shown in Figure 7.
Figure 1 Figure 2
Figure 3 Figure 4
Quick
connect
PC board
connector
Figure 5 Figure 6
“C”
bracket