DreamGEAR DG360-279 es Manuel d'utilisation

Power bricks, User’s guide

Advertising
background image

www.dreamgear.net

Power Bricks

USER’S GUIDE

KEEPING YOUR BATTERY CLEAN:

Be sure and keep your Power Brick Rechargeable Battery clean. Dirt and

debris may harm the battery contacts. Use a dry cloth to clean the battery.

DO NOT use water or any chemicals to clean.

INSERTING YOUR BATTERY PACK:

Press tab on top of the Power Brick and pull down to detach it from the

controller. Insert the battery pack into the battery compartment located on

the back of the controller and lock into place.

NOTE: Avoid pinching your fingers by pushing only on the flat surface of the

Power Brick Rechargeable Battery.
It is very important to charge your Power Brick before the first use and

whenever it is depleted. When the battery is unused for a long time, the Power

Brick may lose its charge. Do not be alarmed if the battery becomes warm

during the charging cycle or use. This does not indicate a problem. It is normal.
It may take up to 20 minutes to have enough power for the Power Brick to be

used. After long period of nonuse, it may take 3 to 5 charging cycles for the

Power Brick to be at its full capacity. Replace the Power Brick when play time

becomes shortened or when it can no longer be charged.

TROUBLESHOOTING:

Problem: The Power Brick charge diminishes too quickly.

Solution: After many charge cycles and as the Power Brick ages, the

amount of play time will decrease. If the play time starts getting shorter or if

the battery does not charge anymore, replace with a new battery.
Problem: Charge time is too slow.

Solution: When charging and playing at the same time, the Power Brick

takes longer to charge. Certain games require vibration, this will also

increase charge time.
Problem: The charge light doesn’t illuminate.

Solution: Make sure the Power Brick is completely locked into the battery

compartment. Detach and re-attach a few times. Check the contacts to see

if they have been damaged.
Problem: The battery isn’t charging.

Solution: Make sure the Power Brick is properly and securely inserted into

the charger. Make sure the contacts on the Power Brick aren’t damaged or

compromised.

CONTENTS:

• 2 Power Bricks

• User’s Guide/Warranty Card

• Registration Card

Advertising