Candy CC2 76T-47 - Manuel (Page 13)

The water removed from the laundry during the
drying cycle is collected in a container at the
bottom of the dryer.
When the container is full the Réservoir Plein
indicator on the control panel will light, and the
container MUST be emptied. However, we
recommend that the container is emptied after
each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.
To remove the container
1. Gently pull out the tray until it is completely
removed. Support the tray with both hands.
When it is full the water container will
weigh about 4kg.
2. Open the the lid located on the top of the
container and empty the water out. Refit
the lid and slide the water container back
into position. PUSH FIRMLY INTO PLACE.
NOTE: If you have the option of drainage near
the dryer it is possible to use the discharge kit to
provide a permanent drain for the water
collected by the dryer. This will remove the need
to empty the water tray. All the information for
assembly of the kit is contained in the kit
envelope.
13
Water Container
40003498.qxd 05/07/2005 18:01 Page 13