Candy GO DC 36-47 - Manuel (Page 11)

Control panel and indicator lights
Programme Selector – Select the required programme
‘Marche Arrêt’ button and indicator – Press to switch on, the indicator will light
‘Départ’ – Press Départ to commence the selected drying programme. Press for 5 seconds
to cancel/reset the programme
‘Séchage Délicat’ button – Press to reduce the heat level for delicate items, the indicator
above the button will light up. To change the heat setting the programme must be reset
Low Heat – Indicator light ON
High Heat – Indicator light OFF
‘Plein’ indicator – Lights when the water container is full
‘Filtre’ indicator – Lights when the filter needs cleaning
‘Départ Différé’ button – Allows the user to delay the start of the drying cycle (see
details of operation page 16)
Display
START – When the dryer is switched On the START indicator will flash, when the
programme starts the START indicator will light up
60' – Indicator lights when there is less than 60 minutes left until completion of the
programme
15' - Indicator lights when there is less than 15 minutes left until completion of the
programme. At this stage of the drying cycle the machine enters the Cool Down phase
STOP - Indicator lights when the programme is finished
6h - 6 hour start delay (light flashes when in operation)
9h - 9 hour start delay (light flashes when in operation)
11
Controls and indicators
ACRYLICS/
SYNTHETICS
BUTTON
(Séchage
Délicat)
ON/OFF
BUTTON
(Marche
Arrêt)
FILTER CARE
INDICATOR
(Filtre)
EMPTY
WATER
INDICATOR
(Plein)
PROGRAMME
SELECTOR
START
BUTTON
(Départ)
START DELAY
BUTTON
(Départ
Différé)
COUNTDOWN DISPLAY
40005088Eng.qxd 30/06/2007 17:52 Page 11