Yamaha YST-SW40 - Manuel (Page 8)

CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER
• Leave the main speakers connected to the amplifier.
• Amplifier line output terminals are generally labeled PRE OUT or SUBWOOFER OUT.
*
For PRE OUT terminal connection, the amplifier must possess at least two sets of PRE OUT terminals. With some amplifiers
with only one set of PRE OUT terminals, connection can result in no sound from the main left and right speakers. In this
case, select the method of connecting to the speaker terminals.
• To connect with a YAMAHA DSP amplifier, connect the LOW PASS (or SUBWOOFER etc.) terminal on the rear of the DSP
amplifier to either the left (L) or right (R) INPUT 2 terminal.
If using one unit
If using two units
Notes
•
When connected to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT terminals on
the rear panel of this unit. If connected, they will not produce sound.
• When connecting to a monaural line output terminal of the amplifier, connect to either the left or right INPUT 2 terminal.
8
OUTPUT
INPUT1
TO SPEAKERS
FROM AMPLIFIER
INPUT2
ON OFF
AUTO
POWER
PRE OUT
Amplifier
Pin plug cords
Right speaker Left speaker
To AC outlet
This unit
LOW PASS
<
Amplifier
>
< YAMAHA DSP amplifier >
OUTPUT INPUT2
TO SPEAKERS
INPUT1
FROM AMPLIFIER
ON OFF
AUTO
POWER
OUTPUT
INPUT1
TO SPEAKERS
FROM AMPLIFIER
INPUT2
ON OFF
AUTO
POWER OUTPUT
INPUT1
TO SPEAKERS
FROM AMPLIFIER
INPUT2
ON OFF
AUTO
POWER
To AC outlet
This unit
Right speaker Left speaker
Amplifier
PRE OUT
Pin plug
cords
To AC outlet
This unit
OUTPUT INPUT2
TO SPEAKERS
INPUT1
FROM AMPLIFIER
ON OFF
AUTO
POWER
OUTPUT INPUT2
TO SPEAKERS
INPUT1
FROM AMPLIFIER
ON OFF
AUTO
POWER