Dryer care, Warning, Cleaning the dryer location – Whirlpool 8578902A Manuel d'utilisation

Page 19: Cleaning the lint screen

Advertising
background image

19

To use the drying rack

Do not remove the lint screen.

1. Open dryer door.

2. Place drying rack inside dryer drum, positioning the back wire

on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.

3. Put the wet items on top of the rack. Leave space between

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the rack.

4. Close the door.

5. Press the POWER button.

6. Select a timed drying cycle and temperature (see following

chart). Items containing foam, rubber or plastic must be dried
on a clothesline or by using the Air Only temperature setting.

7. You must select a time by pressing TIMING Up or Down.

Reset time as needed to complete drying. Refer to the
following table.

8. Press (and hold) START button (about 1 second).

This chart shows examples of items that can be rack dried and
the suggested cycle, temperature setting and drying time. Actual
drying time will depend on the amount of moisture items hold.

*(Minutes) Reset time to complete drying, if needed.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. A
screen blocked by lint can increase drying time.

To clean

1. Pull the lint screen straight up. Roll lint off the screen with

your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.

2. Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See “Venting
Requirements.”

A. Front edge

A. Dryer rack front edge
B. Dryer back panel

Rack Dry

Setting

Temp.

Time*

Wool Sweaters

Block to shape and lay flat on
the rack.

Timed
Dry

Low

60

Stuffed toys or pillows

Cotton or polyester fiber filled

Timed
Dry

Low

60

Stuffed toys or pillows

Foam rubber filled

Timed
Dry

Air Only

(no heat)

90

Sneakers or canvas shoes

Timed
Dry

Air Only

(no heat)

90

A

A

B

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.

Failure to do so can result in death, explosion, or fire.

Advertising