Whirlpool YGR556 - Manuel (Page 15)

15
To Disable Automatic Warm/Cool: Press and hold WARM for 5
seconds. “OFF” will appear in the 4-digit display. Repeat to turn
back on.
IMPORTANT: Food must be at serving temperature before
placing it in the warmed oven. Food may be held up to one hour,
however breads and casseroles may become too dry if left in the
oven during Warm Hold.
To Use In Stand-Alone Mode:
1. Press WARM.
2. Set the temperature (optional).
3. Press the TEMP “up” or “down” arrow pad to raise or lower
the temperature in 5°F (3°C) amounts to set a temperature
other than 170°F (77°C). The warm range is 100°F-200°F
(38°C-93°C).
4. Press START.
5. Press STOP CANCEL when finished.
Timed Cooking
Timed Cooking allows the oven to be set to turn on at a certain
time of day, cook for a set length of time, and/or shut off
automatically. Delay start should not be used for food such as
breads and cakes because they may not bake properly.
To Set a Cook Time:
1. Press BAKE (optional).
2. Press the TEMP “up” or “down” arrow pads to enter a
temperature other than the one displayed.
3. Press STOP TIME.
4. Press the HR and MIN “up” or “down” arrow pads to enter
the desired time to end cooking.
5. Press START. The display will count down the time.
When the time ends, the oven will shut off automatically and
“End” will appear on the display and end-of-cycle tones will
sound.
6. Press STOP CANCEL or open and close the oven door to
clear the display and/or stop reminder tones.
To Set a Delayed Cook Time:
Before setting, make sure the clock is set to the correct time of
day. See “Clock” section.
NOTE: When setting a delayed cook time (either with or without a
sequence program), if the delayed start cook time is longer than
one hour, then the oven will automatically go into a cool cycle.
The cool cycle will continue to run for a maximum of 24 hours, or
until the delayed start cook time or the first step of a program
sequence has been reached.
1. Press desired cook function.
2. Press the TEMP “up” or “down” arrow pads to enter a
temperature other than the one displayed.
3. Press START TIME.
4. Press the HR and MIN “up” or “down” arrow pads to enter
the time of day to start.
5. Press STOP TIME (optional).
6. If STOP TIME has been pressed, press the HR and MIN “up”
or “down” arrow pads to enter the desired time to end
cooking.
7. Press START. “DELAY” will appear on the display.
When the start time is reached, the oven will automatically
turn on. When the stop time is reached (if programmed), the
oven will shut off automatically and “End” will appear on the
display and end-of-cycle tones will sound.
8. Press STOP CANCEL or open and close the oven door to
clear the display and/or stop reminder tones.
RANGE CARE
Self-Cleaning Cycle
(on some models)
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off during the Self-Cleaning cycle. Exposure to
the fumes may result in death to certain birds. Always move birds
to another closed and well ventilated room.
Self-clean the oven before it becomes heavily soiled. Heavy soil
results in longer cleaning and more smoke.
Keep the kitchen well-ventilated during the Self-Cleaning cycle to
help get rid of heat, odors, and smoke.
Do not block the oven vent(s) during the Self-Cleaning cycle. Air
must be able to move freely. See “Oven Vent(s)” section.
Do not clean, rub, damage or move the oven door gasket. The
door gasket is essential for a good seal.
WARNING
Food Poisoning Hazard
Do not let food sit in oven more than one hour
before or after cooking.
Doing so can result in food poisoning or
sickness.
WARNING
Food Poisoning Hazard
Do not let food sit in oven more than one hour
before or after cooking.
Doing so can result in food poisoning or
sickness.
WARNING
Burn Hazard
Do not touch the oven during the
Self-Cleaning cycle.
Keep children away from oven during
Self-Cleaning cycle.
Failure to follow these instructions can result
in burns.