Surface grates with locator pin, Home canning – Whirlpool SCS3617 Manuel d'utilisation

Page 7

Advertising
background image

7

Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Protect it from spillovers
by always using a burner cap.

Burner ports: Check burner flames occasionally for proper size
and shape as shown above. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.

To Clean:

IMPORTANT: Before cleaning, make sure all controls are off and
the cooktop is cool. Do not use oven cleaners, bleach or rust
removers.

1. Remove the burner cap from the burner base and clean

according to “General Cleaning” section.

2. Clean the gas tube opening with a damp cloth.

3. Clean clogged burner ports with a straight pin as shown. Do

not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.

4. Replace the burner cap, making sure the alignment pins on

the cap are properly aligned with the burner base.

5. Turn on the burner. If the burner does not light, check cap

alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.

Surface Grates with Locator Pin

Surface Grates

The grates located on the left and right side of the cooktop
contain grooves. These grooves must always face inward toward
the control knob panel to hold the grates in place. On some
models, the middle grate must be placed in position first,
followed by the left and right grates.

Locator Pin

The locator pin on the grate must be positioned in the burner cap
hole to hold the grate in place.

Home Canning

When canning for long periods, alternate the use of surface
burners between batches. This allows time for the most recently
used areas to cool.

Center the canner on the grate.

Do not place canner on 2 surface burners at the same time.

For more information, contact your local agricultural
department. Companies that manufacture home canning
products can also offer assistance.

A. 1-1

¹⁄₂" (25-38 mm)

B. Burner ports

A. Incorrect
B. Correct

B

A

A

B

A. Left grate
B. Middle grate

C. Groove

A. Locator pin
B. Burner cap

A

B

C

A

B

Advertising