Whirlpool 929 - Manuel (Page 18)

18
SETTING THE CONTROLS
Changing a cycle or an option setting
During the first minute of a cycle
1. Press new Cycle and/or Option pads.
2. Check the detergent dispensers. They
must be filled properly for the new cycle.
After the first minute of a cycle
1. Press Cancel/Drain. A 2-minute drain
cycle starts. Wait for drain cycle to finish.
2. Press a new Cycle pad.
3. If desired, press one or more Option pad(s).
To cancel an option, press the pad again.
4. Check the detergent dispensers. They
must be filled properly for the new cycle.
Adding items during a cycle
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
You can add an additional item to the dish-
washer anytime before the main portion of a
cycle. See the “Selecting a wash cycle”
chart.
8051221 v13 EN (c32) 6/24/98 2:25 PM Page 18