Whirlpool 910 Series - Manuel (Page 6)

6
1. Load the dishwasher. See the “Loading
Your Dishwasher” section.
2. Spin the spray arms. They should turn
freely.
3. Add detergent. See the “Using the
Dispensers” section.
4. Add rinse agent, if needed.
5. Close door firmly until it latches.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
• Open the door slightly. Wait for any filling
or spraying action to stop before opening
the door all the way. Close the door to
continue the cycle.
6. Run hot water at the sink nearest the
dishwasher until water is hot.
Turn off water.
7. Press a Cycle pad. If desired, press one
or more Options pads. See
the ”Setting the Controls”
section.
NOTE: Normal Wash, Light
Wash and Rinse Only share
the same pad. The Cycle Control knob
determines which cycle operates.
8. Turn the Cycle Control knob clockwise to
the desired cycle. You will
feel a definite “stop” at each
cycle mark. The dishwasher
automatically starts the cycle
you select.
NOTE: If the door is latched, you will
hear the cycles start and stop as the
control knob passes each cycle mark.
This is normal and does not hurt the
dishwasher. If you prefer, you can set
the Cycle Control knob with the door
unlatched.
Starting a wash cycle
OR
• Turn the Cycle Control knob slowly
clockwise until you hear water draining.
Let the dishwasher drain completely. Then
open the door and turn the Cycle Control
knob to Off.
STARTING YOUR DISHWASHER
8051220 v15 (c41) 7/1/98 9:08 AM Page 6