Whirlpool W10178072B - Manuel (Page 5)

5
5.
align sides of pedestal
Align the sides of the pedestal so that they are even with the
sides of the washer/dryer. Reach inside the pedestal opening
and securely tighten all four pedestal screws.
7.
Stand the washer/dryer upright
Tip the washer/dryer back to its upright position. Remove
and discard any remaining packaging material.
COMPLETE THE INSTALLATION
Follow the installation instructions that came with your model
to finish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
note: Be sure to remove the transport bolts from the back
of the washer.
8.
move close to final location
9.
Check levelness
of washer/dryer
Not Level leVel Not Level
Place level here
Place a level on top edges of washer/dryer, checking each
side and front. Rock washer/dryer back and forth to make
sure all four feet make solid contact with floor.
If not level, adjust pedestal feet up or down, repeating as
necessary.
The pedestal arrives with the feet tight against the bottom
of the unit. Using a 1/4" hex-head ratchet or open-end
wrench, lower the feet approximately 1" (25 mm) away
from the bottom of the pedestal.
1"
(25 mm)
6.
Prepare pedestal feet