Whirlpool 99044505A - Manuel (Page 11)

11
Make Electrical Connection
Direct Wire Installation
1. Connect the white wire of the home power supply cable with
the white wire in the range hood using a UL listed wire
connector.
2. Connect the black wire of the home power supply cable with
the black wire in the range hood using a UL listed wire
connector.
3. Connect ground wire (green or bare) of home power supply
cable to the green ground screw in the terminal box.
4. Tighten strain relief screws.
5. Install the terminal box cover.
6. Reconnect power.
Complete Installation
Install 40-watt (max) type A-15 appliance light bulbs.
1. Squeeze both sides of the lens cover to remove the tabs from
the slots in the range hood and remove lens cover.
2. Screw two 40-watt light bulbs into sockets.
3. Reinstall lens cover by squeezing both sides of the lens cover
and inserting the tabs into the slots in the range hood.
Install Charcoal filter
For non-vented (recirculating) installations:
Install charcoal filter pad Part Number 4396388 available from
your dealer. See “Range Hood Care” section for installation
instructions.
Check Range Hood Operation
1. Check light operation by turning the light knob.
2. Check operation of fan by turning the fan knob.
3. If the range hood does not operate, check to see whether a
circuit breaker has tripped or a house fuse has blown.
4. NOTE: To get the most efficient use from your new range
hood, read the “Range Hood Use” section.
A. White wires
B. Black wires
C. Green ground screw
D. Ground wire
E. UL listed or CSA approved strain relief
F. UL listed wire connector
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in
terminal box.
Failure to do so can result in death, fire, or
electrical shock.
A
B
C
D
E
F
A. Light bulb socket
B. Lens cover
C. Lens cover slots
D. Lens cover tabs
A
B
C
D