Thermador Pro-Harmony P36 - Manuel (Page 9)

6
GAS AND ELECTRIC SUPPLY
Step 2: Cabinet Preparation
FIG. 3A Gas & Electrical Supply Locations for All Gas Ranges
The All Gas ranges may be connected to the power supply with a range supply cord (supplied with range)
or by hard-wiring to the power supply. It is the responsibility of the installer to provide the proper wiring
components (cord or conduit and wires) and complete the gas connection as dictated by local codes and
ordinances, and/or the National Electric Code. The units must be properly grounded. Refer to Step 6 for
details.
The range must be connected only to the type of gas for which it is certified. If the range is to be
connected to propane gas, ensure that the propane gas supply tank is equipped with its own high
pressure regulator in addition to the pressure regulator supplied with the range. (See STEP 5.)
NEMA 5-20
RECEPTACLE
PLUG
8 1/2"
6" 6 " 6" 6"
1 3/4"
30 1/4" (30" models)
36 1/4" (36" models)
1 3/4" maximum protrusion
from wall for gas or
electrical supply
electrical
supply zone
gas
supply zone
NOTE: If not already present, install gas shut-off valve in an easily accessible location. Make sure all
users know where and how to shut off the gas supply to the range.
NOTE: The installer should inform the consumer of the location of the gas shut-off valve.
NOTE: An opening in the wall behind the appliance and any opening in the floor under the appliance must be
sealed.
NOTE: The range is designed for flush installation to the back of the wall.
For a successful installation, it may be necessary to reposition the gas-
supply line and electrical cords as the range is pushed back to its final
installed position.
IMPORTANT:
The cord supplied with the gas ranges, having an electric griddle,
requires a NEMA 5-20 receptacle, shown here. Local codes may
require a different wiring method.