TRENDnet TFC-1000 - Manuel (Page 15)

Troubleshooting
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
After connecting the Fiber Converter, the LEDs do not turn on. What
should I do?
First, check that the power outlet is receiving power. Second, make
sure the power adapter is firmly connected to the Fiber Converter and
the power outlet. Third, make sure the Ethernet and the Fiber cables
are connected.
All the LEDs are on, but I can't make a connection. What should I do?
First, verify that you are using the proper fiber cable (e.g. multi-
mode fiber cable for multi-mode converters; single-mode fiber cables for
single-mode converters). Second, verify that the TX and RX cables
have been reversed on the opposite Fiber connection. Third, power
down the Fiber Converters and the switches. Wait 15 seconds, then
plug the switches and the Fiber Converters back in.
What is the maximum distance that is supported by the Fiber Converter?
Please refer to Product Detail for distance information.
After connecting the Chassis to a power outlet, the LEDs do not turn on.
First, check that the power outlet is receiving power. Second, make
sure the power cord is firmly connected to the chassis and the power
outlet. Third, make sure the power switch is flipped to the
ON position.
If you still encounter problems or have any questions please contact TRENDnet's
Technical Support Department.
13