Operating instructions, Brewing coffee - immediate start – Toastmaster MEFB6W Manuel d'utilisation

Page 8

Advertising
background image

NOTA: Lorsque vous utilisez le mode de départ immédiat après
avoir effectué un cycle programmé, sans débrancher la cafetière, il
peut être nécessaire d’appuyer sur le bouton AUTO ON/OFF deux
fois. La première fois, le voyant lumineux clignotera; la deuxième
fois, le voyant s’allumera en permanence et la préparation com-
mencera.

8. Si vous désirez servir une tasse de thé avant que le cycle de prépa-

ration ne soit terminé, retirer simplement la carafe de la plaque
chauffante. L’égouttement cessera automatiquement. Remettre la
carafe en place sur la plaque chauffante dans les 30 secondes; l’é-
gouttement reprendra. Si la carafe n’est pas replacée sur la plaque
chauffante, l’eau chaude pourrait déborder du porte-filtre.

9. Lorsque la préparation est terminée, l’appareil change de mode afin

de garder le liquide chaud; il gardera le thй а la température requise
pour le servir. Pour garder le thé chaud, replacer la carafe sur la
plaque chauffante lorsque vous ne servez pas.

NOTA: Selon les goûts et le type de thé infusé, vous pouvez choisir
de laisser le thé infuser plus longtemps avant d’enlever le panier et
de servir.

ATTENTION: La carafe, le couvercle et le panier pour infuser le
thé sont chauds après la préparation! Soyez très vigilants
lorsque vous manipulez ces pièces.

10. Appuyer sur le bouton AUTO ON/OFF une autre fois pour éteindre

l’appareil lorsque vous ne vous en servez pas. Lorsque le cycle de
préparation est terminé, l’appareil s’éteindra automatiquement après
deux heures. L’indicateur lumineux s’éteindra.

11. Laisser refroidir la cafetière pendant 10 minutes entre les cycles.

ATTENTION: La plaque chauffante est chaude! Ne pas toucher le
bas de la carafe ni la plaque chauffante pendant la préparation ni
après celle-ci.

NOTA: La quantité de thé dans la carafe peut être légèrement inférieure
à la quantité d’eau qui a été versée dans le réservoir d’eau, car une cer-
taine quantité d’eau est absorbée par les feuilles ou les sachets de thé.

NOTA: La fonction programmable doit être réglée de nouveau après

avoir été utilisée.

14

7

OPERATING INSTRUCTIONS

Brewing Coffee - Immediate Start

NOTE: When brewing coffee, the Tea Infusion Basket is not need-
ed. To remove the Tea Infusion Basket, prop the Carafe Lid open
with one hand and with the other hold the rim of the Tea Infusion
Basket. The tab on the outer rim of the Tea Infusion Basket will be
aligned with the position located on the bottom side of the
Carafe Lid. Turn the Tea Infusion Basket counter-clockwise until the
tab aligns with the position located on the bottom of the
Carafe Lid. Remove the Tea Infusion Basket and close the Carafe
Lid.

1. Plug the appliance into a standard 120V AC electrical outlet.

2. Markings on the Carafe indicate the level of water required to brew

the desired number of cups. Fill the Carafe with cold tap water.
Close the Lid back into position.

NOTE: Brewing less than 4 cups is not recommended.

3. Lift up the hinged lid on the top of the unit and slowly pour water into

the Water Chamber.

4. Grasp the Removable Filter Holder and lift straight up and out of the

Filter Cavity. Insert a #4 paper coffee filter inside the Removable
Filter Holder.

We recommend using Melitta #4 cone-shaped filters.

5. Place coffee grounds in the filter, using one level tablespoon of drip

grind coffee for each cup of brewed coffee.

6. Replace the Removable Filter Holder by pushing it down into the

Filter Holder Cavity. When properly seated, the tab on the Filter
Holder will be positioned on the front of the Holder Cavity.

7. Set the Brew Strength Control to the desired strength.

8. Place the Carafe onto the Warming Plate. Make sure the Carafe is

positioned correctly on the Warming Plate under the Auto Pause and
Pour Assembly.

9. Press the AUTO ON/OFF Button once. The Indicator Light will turn

on and the brew cycle will begin.

Advertising
Ce manuel est liée aux produits suivants: