TRENDnet TEG-S2400I - Manuel (Page 7)

Q1.
A1.
Q2.
A2.
Q3.
A3.
How come I cannot see any light from any of my LED's?
Your TEG-S2400i/TEG-S2600i is not getting any power. Make
sure that your surge protector or your outlet is getting power and make
sure that the AC Power cord is properly connected to your switch.
After connecting several workstations to the switch, I have all
workstations communicating with the server, but I cannot access the
switch's web configuration utility. What should I do?
Please change your switch's IP address to match the network
segment of your workstations. For configuring your switch's IP address,
please consult the User's Guide.
I have connected several workstations into the switch, but one
workstation does not connect to the network. The LEDs on one of the
ports remain unlit, while the rest of the ports have blinking LEDS. What
do I do?
You either have a faulty network card or a faulty network patch cable.
Make sure that your network card and network cable are functional.
If you have any questions regarding your switch please contact TRENDnet
Technical Support Department.
5
Troubleshooting
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may cause
undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.