Tektronix Phaser Laser Printers 740L - Manuel (Page 25)

Getting Set Up
Setup Guide 17
Connect the interface cables
Included here is an overview of the printer ports. If you are connecting the
printer directly to your computer, refer to “Connecting to the parallel port” on
page 18. If you are connecting the printer to a network, refer to the PhaserShare
Networking Setup Guide.
Printer port overview
N O T E
Plus, Duplex, and Extended Configurations include a SCSI port; Standard
Configurations require the Z740FP Kit for SCSI support.
The printer is shipped with two interface ports on the printer’s rear panel.
Optionally, it supports a SCSI port and one of three optional PhaserShare
®
network cards. All ports and network protocols are simultaneously active.
1. Ethernet standard 10BASE-T interface
Refer to the PhaserShare Networking Setup Guide.
2. Parallel standard Standard (bi-directional) parallel port
Refer to “Connecting to the parallel port” on page 18.
3. SCSI optional For optional peripheral devices
Refer to “Connecting a SCSI peripheral device” on page 19 and
“Connecting peripheral devices” on the printer’s CD-ROM or web site.
4. PhaserShare Card optional 10/100BASE-T, Token Ring, or LocalTalk
Refer to the PhaserShare Networking Setup Guide.
3101-15
SCSI
2
3
4
1
Parallel
Ethernet
100 Mbs
10/100Base-TX
10Base2
TP LINK
TX RX
PhaserShare
TM
Series B
Ethernet Card PhaserShare
TM
Series B
Token Ring Card
TX RX
INS 16 Mbs
STP
UTP
TX RX
LocalTalk®
PhaserShare
TM
Series B
LocalTalk Card