Cleaning recommendations – Thermador P30 P36 Manuel d'utilisation

Page 35

Advertising
background image

Cleaning Recommendations

Part/Material

Cleaning Products/Directions

General Kitchen Cleaners: Formula 409

®

, Fantastik

®

.

Spray on and blot dry with a cloth. Do not rub. Do not move, remove
or damage mesh.

Seal

Door Gasket

See Oven Cavity, Page 32.

Interior

Porcelain Enamel

Use care to keep cleaners and water away from the door vents. If water
or cleaners spill into the vents, water may streak the glass inside.

See Cooktop, Back Panel, Stainless Steel, Page 30.

Exterior, Frame, Handle,
Heat Deflector

Stainless Steel

Hot sudsy water.

Wash, rinse thoroughly, and dry.

Cleaners: Soft Scrub

®

.

Apply with a damp sponge or cloth according to manufacturer’s
directions. Rinse and wipe dry.

Powdered Cleanser: Bon-ami

®

, Comet

®

, Ajax

®

.

Apply with a damp sponge or cloth according to manufacturer’s
directions. Rub lightly. Rinse thoroughly and wipe dry.

Soap filled fiber or steel wool pads: S.O.S

®

, Brillo

®

.

Dampen pad, rinse thoroughly, and dry.

Harsh Cleaners: Easy Off

®

Oven Cleaner.

NOTE: Some commercial oven cleaners cause darkening and

discoloration. Test the cleaner on a small part of the rack and
check for discoloration before cleaning the entire rack.

Apply a generous coating. Allow to stand for 10 to 15 minutes.
Rinse thoroughly and wipe dry.

If the racks do not slide easily after being cleaned, dampen a paper
towel with a small amount of cooking oil and rub it lightly over the side
rails.

Oven Racks and Rack Guides

Nickel Plated

NOTE:
The rack guides are removable,
for cleaning using this procedure
(see removel instructions below).

See Cooktop, Back Guard, Page 30.

Front Frame

Stainless Steel

33

SECTION SIX: CARE AND MAINTENANCE

Rack Guide removal, for cleaning:

1. Lift the front of rack guide to clear the heads of the two

shoulder bolts at the front of the oven cavitiy.

2. Remove the front portion of the rack guide by pulling the

guide's key slots over the shoulder bolts.

3. Pull the two rails out of the holes in the back of the oven

cavity.

Note: The rack guides are designed to fit either side of the oven
cavity.

Advertising