Tasco Digital Trail Camera 119213C - Manuel (Page 12)

FCC Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and
receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/TV
technician for help.
Shielded interface cable must be used with the
equipment in order to comply with the limits for a
digital device pursuant to Subpart B of Part 15 of FCC
Rules.
Specifications and designs are subject to change
without any notice or obligation on the part of the
manufacturer.
ONE YEAR LIMITED WARRANTY
Congratulations on the purchase of your new Tasco product. You have chosen one
of the finest values available today. This product carries Tasco’s ONE YEAR LIMITED
WARRANTY. This product is warranted against original defects in material and/or
workmanship for the length of time specified by this warranty, provided, however,
that the unit has not been abused, taken apart or tampered with in any way
whatsoever.
This warranty is limited to the original purchaser and is not transferable. This warranty
applies only to products purchased in the United States of America. Any return
made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $10.00 to cover the cost of
postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton to
prevent damage in transit, with return postage prepaid to the address
listed below:
SEND TO: TASCO
Attn.: Repairs
8500 Marshall Drive
Lenexa, Kansas 66214
Tasco shall not be liable for any consequential, incidental or contingent damages
whatsoever. Some states do not allow the exclusion of incidental or consequential
damages, so the above limitation or exclusion may not apply to you. This warranty
gives you specific legal rights, and you may have other rights which vary from state
to state.
Non-warranty repairs or refurbishing of your Tasco product are always provided at a
reasonable cost. For products purchased outside the United States please contact
your local dealer for applicable warranty information.
©2010 B.O.P Tasco, TM, ®, denote trademarks of B.O.P