Onkyo HT-R758 - Manuel (Page 40)

Turning On & Basic Operations
En-40
When you connect an -capable Onkyo component, you
must configure the input display so that can work
properly.
This setting can be done only from the front panel.
The Music Optimizer function enhances the sound quality
of compressed music files.
You can temporarily mute the output of the AV receiver.
Changing the Input Display
1 Press TV/CD or GAME.
“TV/CD” or “GAME” appears on the AV receiver’s
display.
2 Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
Note
“
• “DOCK” can be selected for the “TV/CD” or “GAME”
input selector, but not at the same time.
• Enter the appropriate remote control code before using the
remote controller for the first time ( ➔ page 59 ).
TV/CD
→
DOCK
→
→
TAPE
■ TV/CD:
GAME ↔ DOCK ■ GAME:
Using the Music Optimizer
1 (North American models) Press MUSIC
OPTIMIZER on the front panel.
The M.Opt indicator lights on the AV receiver’s
display.
The MUSIC OPTIMIZER indicator lights on the
front panel.
Tip
• Alternatively, you can use Q SETUP on the remote
controller.
• See “Music Optimizer” for more details ( ➔ page 43 ).
Muting the AV Receiver
1 Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the AV receiver’s display.
Tip
• To unmute, press MUTING again or adjust the volume.
• Muting is automatically cancelled when the AV receiver is
set to standby.
Using Headphones
1 Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the
PHONES
jack.
While the headphones plug is inserted in the PHONES
jack,
indicator lights.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off.
• When you connect a pair of headphones, the listening mode
is set to Stereo, unless it’s already set to Stereo, Mono,
Direct, or Pure Audio (European and Australian models).
• If you connect an iPod or iPhone to the USB port on the AV
receiver, no sound will be output from the headphones jack.