RCA F32350 - Manuel (Page 9)

Using the Remote Control
Chapter 2 7
Illustrations contained in this document are for representation only.
SKIP If you press this button before you change the channel, the TV waits 30 seconds and goes back to the
original channel. Each time you press SKIP, you add 30 seconds (i.e, if you press SKIP two times, the TV waits
60 seconds and turns back to the original channel). Press CLEAR to cancel skip timer.
SOUND Displays the AUDIO PROCESSOR menu.
STOP If you’re operating a VCR or DVD player, stops playing the videotape or disc.
TV Turns on the TV and puts the remote in TV mode. Also displays channel information.
VCR1 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR1
button tunes the TV to the correct channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR2
button tunes the TV to the correct channel.
VOL (up and down) buttons Decrease or increase the TV’s volume.
INPUT In TV mode, press INPUT to toggle through the available Video Input channels (FRNT, VID1/SVID1,
VID2/CVID2, VPORT and the current channel). In SAT mode, press to select available channel lists.
Using the INPUT Button
Use the INPUT button to toggle through the available input sources (FRNT, VID1/SVID1, VID2/CVID2, VPORT
and the current channel) and view the content from the component you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the component is turned ON.
2. Press INPUT to tune to the available input source and view the component.
3. Press again to tune back to the channel you were previously watching.
Programming the Remote to Operate Other
Components
The universal remote can be programmed to operate most brands of remote
controllable VCRs, DVD players, audio receivers, satellite receivers and cable boxes.
The remote is already programmed to operate most RCA, GE and Proscan VCRs, DVD
players, audio receivers and satellite receivers. The TV button cannot be programmed.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed, turn a
component ON, such as a VCR, point the remote at the VCR, and press the VCR
button. Then press ON•OFF or channel up or channel down to see if the VCR
responds to the remote commands. If not, the remote needs to be programmed.
How to Program the Remote
There are two ways to program the remote control: automatic code search and direct
entry. Instructions for both ways follow.
Use these buttons
when you
program the
remote to operate
another
component.
The remote may
not operate all
models of all
brands.
STOP
ON OFF
AUX DVD SAT CABLE
PLAY REVERSE
CH +
CH -
V O L V O L
VCR1
VCR2
CLEAR