Remington EL-7 16-inch - Manuel (Page 7)

7 105020
OWNER’S MANUAL
For more information, visit www.desatech.com
ASSEMBLY
Continued
FILLING OIL TANK
1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
Note: For temperatures below -1 °C,
use SAE #10 oil. For temperatures
above 24
°C, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap
firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw
is not in use. Empty oil tank , tighten oil
cap, and store upside down after each use
to prevent seepage. Mounting
Stand-Outs
Guide Bar
Bolts
Guide Bar
Nuts
Adjusting
Hole
Guide
Bar
Tapping
Screw
Saw
Chain
Cutting
Edge
Towards
Guide
Bar Nose
Front Hand
Guard
Drive
Sprocket
Adjusting
Plate
Adjusting
Screw
Sprocket
Support
Adjusting
Block
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Figure 4 - Part Locations For Assembling Guide Bar
Cutting
Edge