Remington FLEX360 R-4130 - Manuel (Page 4)

1. Pull trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns. (Diagram G)
3. Close trimmer by pressing down. (Diagram H)
7
■ Ensure your skin is dry and free of oils.
■ Wait at least 15 minutes after getting up before shaving, to ensure your face is
free of puffiness that may be present from sleeping.
■ Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
■ Stretch skin with the free hand so hairs stand upright, making it easier for them
to enter the cutting chamber.
■ Use moderate to slow, circular stroking movement.
■ The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
■ Do not press hard against the skin to avoid skin irritation and/or damage to the
rotary heads.
**Remington recommends that you use your new shaver daily for up to four
weeks to allow time for your hair and skin to become accustomed to the
new shaving system**
6
Shaving Tips
Trim
Charging
Before using, read the important safety instructions in front of the manual.
1. Plug power adaptor into shaver. (Diagram A)
2. Plug power adaptor into wall outlet. (Diagram B)
3. Charge shaver for 24 hours. Note: During initial charge ignore the electronic
indicators as they are in "start up cycle". (Diagram C)
4. Use shaver until recharge is required.
5. Repeat steps 3 & 4 for at least three times before batteries have been properly
conditioned.
CAUTION!
■
Make sure the shaver and your hands are dry when charging the shaver.
■ Always charge the shaver in a cool, dry place.
Shaving
1. Press power button to turn on. (Diagram D)
2. Shave face and neck using short, circular strokes. (Diagram E)
A B C
A B D E
F G H
36291_R-41-51-7130 IB.indd 6-7 5/21/08 4:37:03 PM