RCA 27V510T - Manuel (Page 25)

Chapter 5 23 Graphics contained within this publication are for representation only.
Other Information
No sound, picture okay
• Maybe the sound is muted. Try pressing the volume up button to restore sound.
• If using S-Video remember to also connect the component’s left and right audio output
jacks to the TV’s AUDIO jacks.
Can’t select certain channel
• Channel may be blocked or not approved through the V-Chip.
• If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct
mode (press the TV/VCR button on your VCR).
Noisy stereo reception
• May be a weak station. Access the SOUND menu, highlight Sound Type and then
choose Mono.
No picture, no sound but TV is on
• Maybe the signal type is set wrong. Go to page 20 for detailed instructions.
• The channel might be blank — change channels.
• If you’re watching your VCR and it’s connected with coaxial cable to the TV ANT jack,
tune the TV to channel 3 or 4 (whichever channel is selected on the 3/4 switch on the
back of your VCR). Also check to make sure the TV/VCR button on the VCR is in the
correct mode (press the TV/VCR button on your VCR).
Sound okay, picture poor
• Check antenna connections. Make sure all of the cables are firmly connected to the
jacks.
• Try adjusting sharpness function to improve weak signals. Go to page 19 for more
instructions.
Black box appears on the screen
• Closed caption might be on. Check Closed Caption in the SETUP menu. Go to page 20
for more instructions.
The Remote Control Doesn’t Work
• Something might be between the remote and the remote sensor on the component.
Make sure there is a clear path.
• Maybe you are trying to operate a component that isn’t a compatible RCA, GE, or
Proscan brand.
• Maybe the remote isn’t aimed directly at the component (DVD, TV, VCR) that you’re
trying to operate.
• Maybe remote is not in TV Mode. Press the TV button so remote will control TV.
• Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in
the remote.
• You might need to reset the remote: remove batteries and press the number 1 button
for at least 60 seconds. Release the 1 button, replace the batteries.
1634765A.05_Other 4/22/04, 9:25 PM 23