NuTone TWO-NOTE WIRELESS CHIME LA-205WH - Manuel (Page 2)

REMOVING THE RECEIVER COVER
Refer to Figure 4.
1. Press the center of the battery cover,
and slide cover toward bottom of
receiver.
2. Set battery cover aside.
RECEIVER SECURITY CODING
Refer to Figure 5.
Changing the Security Code is not
necessary unless you have changed
the security code in the Transmitter.
Both the Transmitter and Receiver
codes must match.
1. Remove the same jumpers in
the Receiver as in the Transmitter.
INSTALLING BATTERIES IN RECEIVER
Refer to Figure 5.
Refer to figure 5 for
placement and polarity
of batteries. The NuTone
Wireless Chime Receiver
requires three AA size
alkaline batteries.
ATTACHING THE
BATTERY COVER
Position battery cover
flush to back of Receiver,
and slide cover up until
it snaps in place.
MOUNTING OF RECEIVER
Refer to Figure 6.
Receiver may be used
as a portable receiver
or may be wall mounted.
Use the following
procedure when mounting
the Receiver to the wall.
1. Select the desired
mounting location.
This location should
be at least 1 foot away
from metal objects and
within 100 feet of the
chime transmitter.
2. Drill one 3 ⁄
16
” hole at the
desired mounting height.
3. Insert the plastic anchor
into the 3 ⁄ 16 ” hole.
4. Drive the screw into the plastic anchor until the head
of the screw extends approximately 1 ⁄
8
” from the mounting surface.
5. Place the keyhole slot in the Receiver base over the screw head.
Slide the Receiver down to secure it.
6. Level the chime Receiver on the mounting surface.
ON/OFF SWITCH AND VOLUME CONTROL
1. Slide the switch up one step to turn on the Receiver
in the low volume position.
2. Slide the switch to the top position to turn on the Receiver
in the high volume position.
NOTE: Receiver battery life can be extended by operating
the volume in the low position.
+ –
+ –
+ –
65 4 3 2 1
SECURITY CODE
SETTING
FIGURE 4
CHIME
RECEIVER
1 ⁄ 8 ”
KEYHOLE
SLOT
PRESS AND SLIDE
BATTERY COVER
TOWARD BOTTOM
OF RECEIVER
FIGURE 6
TROUBLESHOOTING GUIDE
PROBLEM
1. Chime does not sound. Check batteries and polarity.
Make sure receiver or transmitter
is not located on metal surface.
Check receiver and transmitter security
code.
These codes must match.
2. Chime changes tone. Check batteries in receiver.
3. Chime looses volume. Check batteries in receiver.
4. Chime is activated by another
wireless device.
Change the security code in the transmitter
and receiver.
These codes must match.
SOLUTION
FIGURE 5
PREPARING THE RECEIVER