NEC A900 - Manuel (Page 5)

Quick Start
Figure A.1
3
15-pin mini D-SUB
Captive Signal Cable
To attach the MultiSync ® A 900 ™ monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync A 900 Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the MultiSync A
900
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync A 900 Macintosh cable adapter, call
NEC Technologies at (800) 820-1230.
4. For download information on the Windows ® 95/98 INF file for your
MultiSync A 900 monitor, refer to the References section of this User’s Manual.
5. Connect one end of the power cord to the MultiSync A 900 monitor and the
other end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
78133961.MultiL 9/10/98, 12:02 PM 5